Custom installations

3 WAYS TO INSTALL ANIGMO CONTROL UNIT:

1. Conventional

2. Flush

3. Recessed
1. Conventional Installation
Control unit is installed just like a regular switch with face sitting on top of the wall surface. Wall plate requires a cutout in the rear to achieve a snug fit. Dimensions of the cutout should be followed strictly. Plates thicker than 3/4 inch are not recommended as the range and performance of the sensor could be effected.
Other dimensions are suggestions only. It is recommended that the weight of the Wall plate does not exceed 2 lbs.
2. Flush Installation
Control unit is installed flush with the wall surface. Wall plates do not require any cutout in the rear. Any generally flat object can be used as a Wall Plate. Plates thicker than 3/4 inch are not recommended as the range and performance of the sensor could be effected. Other dimensions are suggestions only.
3. Recessed Installation
The control unit is installed with the face plate recessed relative to the surface of the wall. This situation is very common when working with thicker wall coverings such as tile, stone or wood. Plates thicker than 3/4 inch are not recommended as the range and performance of the sensor could be effected.
Other dimensions are suggestions only.